Two ways to build a simple blue tooth speaker
Blue tooth speakers with small and convenient to carry by the outdoor activities of the love, if you can make a few so delicate and lovely Blue tooth speakers to use, is not very thoughtful? So how to make a blue tooth speaker? Let's have a look at the self-made methods of two Blue tooth speakers.
Methods one
1. Prepare tools and raw materials
Get a stereo Bluetooth headset, preferably of good quality, an audio cable, a black tape, a pair of scissors, and a stereo.
2. Production methods and steps
Will stereo bluetooth headset. Apart from the edge of the area, the motherboard aside retention, and then remove the battery out, cut through the red and black wires, take out one by one to see the inside of the parts, remember the microphone placed some carefully, then can cut open a audio line, the inside of the line is divided into two strands, one of the strands respectively connected to the red and the black line.
Connected and ready to use black tape wrapped, this is the left channel bluetooth speakers, audio line another will pick up on the mouth of the charging interface, that is, headphones, headphones to head cut off, and can use fire to melt outside wrapping, the copper, so as to ensure that its wire performance, also meet good package became a right channel.
Plug the other end of the audio cable into the audio input end of the audio, you can turn on the Bluetooth pairing mode, as long as you listen to the voice prompt after the pairing is successful, the production is completed, the appearance of the design according to their own preferences.
Method two
1. Collect all parts
Prepare bluetooth audio USB, micro USB charging module (with protection), 5V USB output and 2x5W amplifier, add a mono amplifier if needed, 3.7V lithium battery, 3-position switch, 2 speakers, rubber radiator, wires, support material frame, etc.
2. Assembly and welding
According to the introduction of method 1, all the parts and wires have been connected, and then we can start to deal with Bluetooth USB and voltmeter. Install and weld all of them, so that the main body is ready. The first gear of the 3-position switch is AUX input, and the second gear is Bluetooth mode.
3. Making packing and auditioning
The box of bluetooth speaker can be made of wood or plastic, etc. Wood is more textured, and the audio sound produced is also more effective. After the appearance is installed, it can be tested.
2021 10/29